Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

The Effect of Acid Injection Rate on Carbonate Acidizing Performance in a Two-Dimensional Heterogeneous Model

Document Type : Research Article

Authors
Sepideh Maaref
Pourya Malmir
Aboozar Soleymanzadeh
Hamid Reza Erfani
Khalil Shahbazi
Faculty of Petroleum Engineering, Petroleum University of Technology, Ahvaz, I.R. IRAN
Abstract
Carbonate acidizing modeling presents an effective tool to determine dynamic behavior trends during matrix acidizing treatment. A successful matrix acidizing process requires a minimum volume of injected acid while creating highly conductive wormholes. In this work, the two-scale continuum model was used to simulate carbonate acidizing using finite difference approach.  This model describes the reactive transport of acid at the Darcy scale and determines the local permeability, porosity, pore radius, and solid-fluid interfacial area changes at the pore-scale through structure-property relationships. In this study, a two-dimensional model was employed with constant flow rate inlet boundary condition, constant pressure outlet boundary condition, and no flow boundary condition on the lateral sides. To perform a grid independent verification, the normalized acid concentration was plotted versus mesh elements which, then, results in determining the optimum number of grid blocks. To solve governing equations, finite difference approach was used by employing initial and boundary conditions. The results of the two-dimensional homogeneous model revealed that there is a uniform acid concentration profile with a reduction trend during the model length. A sensitivity study on acid injection velocity in a heterogeneous model showed that there is an optimum injection velocity of 0.33 to 1.5 cm/s in which deep wormholes with a minimal amount of acid are created. Moreover, as time passes, the reactive dissolution process takes place and results in a dynamic change in the model porosity. This model indicated a good capability to qualitatively capture the experimentally observed wormhole propagation and growth.
Keywords
Acidizing
Wormhole
Finite difference
Sensitivity study
Injection velocity

Subjects

[1] Hoefner M., Fogler H.S., Pore Evolution and Channel Formation During Flow and Reaction in Porous Media, AIChE Journal, 34(1): 45-54 (1988).
[2] Panga M.K., Ziauddin M., Balakotaiah V., Modeling, Simulation and Comparison of Models for Wormhole Formation During Matrix Stimulation of Carbonates, Google Patents (2009).
[3] Hill A., Zhu D., Real-Time Monitoring of Matrix Acidizing Including the Effects of Diverting Agents, SPE Production & Facilities, 11(02): 95-101 (1996).
[4] Golfier F., Bazin B., Zarcone C., Lernormand R., Lasseux D., Quintard M., “Acidizing Carbonate Reservoirs: Numerical Modelling of Wormhole Propagation and Comparison to Experiments”, SPE European Formation Damage Conference., Society of Petroleum Engineers (2001).
[5] Daccord G., Touboul E., Lenormand R., “Carbonate Acidizing: Toward a Quantitative Model of the Wormholing Phenomenon”, SPE Production Engineering, 4(01): 63-68 (1989).
[6] Golfier F., Zarcone C., Bazin B., Lenormand R., Lasseux D., Quintrad M., On the Ability of a Darcy-Scale Model to Capture Wormhole Formation During the Dissolution of a Porous Medium, Journal of Fluid Mechanics, 457: 213-254 (2002).
[7] Panga M.K., Ziauddin M., Balakotaiah V., Two‐Scale Continuum Model for Simulation of Wormholes in Carbonate Acidization, AIChE Journal, 51(12): 3231-3248 (2005).
[8] Kalia N., Balakotaiah V., Modeling and Analysis of Wormhole Formation in Reactive Dissolution of Carbonate Rocks, Chemical Engineering Science, 62(4): 919-928 (2007).
[9] Kalia N., Balakotaiah V., Effect of Medium Heterogeneities on Reactive Dissolution of Carbonates, Chemical Engineering Science, 64(2): 376-390 (2009).
[10] Ratnakar R., Kalia N., Balakotaiah V., “Carbonate Matrix Acidizing with Gelled Acids: An Experiment-Based Modeling Study”, in SPE International Production and Operations Conference & Exhibition. Society of Petroleum Engineers (2012).
[11] Qiu XW., Zhao W., Dyer S.J., Al Dossary A., Khan S., Sultan AS., “Revisiting Reaction Kinetics and Wormholing Phenomena During Carbonate Acidising”, in IPTC 2014: International Petroleum Technology Conference. (2014).
[12] Tardy P.M.J., Lecerf B., Christanti Y., “An Experimentally Validated Wormhole Model for Self-Diverting and Conventional Acids in Carbonate Rocks under Radial Flow Conditions”, European Formation Damage Conference. Society of Petroleum Engineers (2007).
[13] Kalia N., Balakotaiah V., “Wormholing in Perforated Completions”, SPE International Symposium and Exhibiton on Formation Damage Control. Society of Petroleum Engineers (2010).
[14] Fredd C., Miller M.. “Validation of Carbonate Matrix Stimulation Models”, SPE International Symposium on Formation Damage Control, Society of Petroleum Engineers (2000).
[15] Cruz-Maya JA., Rosas-Flores JA., Godoy-Alcantar M., Jan-Roblero J., Silva FS., A Real-Time Virtual Monitoring System of the Skin Factor for Matrix Acidizing Treatments, Flow Measurement and Instrumentation, 22(5): 413-420 (2011).
[16] Buijse M.A., “Understanding Wormholing Mechanisms Can Improve Acid Treatments in Carbonate Formations”, SPE European Formation Damage Conference., Society of Petroleum Engineers (1997).
[17] Daccord G., Lenormand R., Lietard O., Chemical Dissolution of a Porous Medium by a Reactive Fluid—I. Model for the “Wormholing” Phenomenon, Chemical Engineering Science, 48(1): 169-178 (1993).
[18] Tansey, J.F., “Pore Network Modeling of Carbonate Acidization”, SPE Annual Technical Conference and Exhibition, Society of Petroleum Engineers. (2014).
[19] Kamath J., Xu B., Lee S.H., Yortsos Y.C., Use of Pore Network Models to Interpret Laboratory Experiments on Vugular Rocks, Journal of Petroleum Science and Engineering, 20(3): 109-115 (1998).
[20] Fredd C.N., Fogler H.S., Influence of Transport and Reaction on Wormhole Formation
in Porous Media, AIChE journal, 44(9): 1933-1949 (1998).
[21] Panga MK., Ziauddin M., Gandikota R., Balakotaiah V., “A New Model for Predicting Wormhole Structure and Formation in Acid Stimulation of Carbonates”, SPE International Symposium and Exhibition on Formation Damage Control, Society of Petroleum Engineers (2004).
[22] Maheshwari P., Balakotaiah V., Comparison of Carbonate HCl Acidizing Experiments with 3D Simulations, SPE Production & Operations, 28(04): 402-413 (2013).
[23] Maheshwari P., Maxey J.E., Balakotaiah V., “Simulation and Analysis of Carbonate Acidization with Gelled and Emulsified Acids”, Abu Dhabi International Petroleum Exhibition and Conference, Society of Petroleum Engineers (2014).
[24] Maheshwari P., Ratnakar R.R., Kalia N., Balakotaiah V., 3-D Simulation and Analysis of Reactive Dissolution and Wormhole Formation in Carbonate Rocks, Chemical Engineering Science, 90: 258-274 (2013).
[25] Ratnakar R.R., Kalia N., Balakotaiah V., Modeling, Analysis and Simulation of Wormhole Formation in Carbonate Rocks with in Situ Cross-Linked Acids, Chemical Engineering Science, 90: 179-199 (2013).
[26] Ghommem M., Zhao W., Dyer S., Qiu X., Brady D., Carbonate Acidizing: Modeling, Analysis, and Characterization of Wormhole Formation and Propagation, Journal of Petroleum Science and Engineering, 131: 18-33 (2015).
[27] Zhu D., Hill A.D., “Field Results Demonstrate Enhanced Matrix Acidizing Through Real-Time Monitoring”, Permian Basin Oil and Gas Recovery Conference, Society of Petroleum Engineers (1996).