Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

Investigation the effect of Injection Pressure of the Hypochlorite sodium on Mechanical and Permeability Properties of the Polysulfone Hollow Fibrous Membranes

Document Type : Research Article

Authors
Reza Saghafi
Javad Yekrang
Textile Engineering Group, University of Bonab, Bonab, I.R. IRAN
Abstract
Recently, the high pressure injection technique has been introduced for hypochlorite treatment of hollow fibrous membranes. In this process, the hypochlorite solution is injected into the channels of fibers at a high pressure. Literatures show that this technique is more efficient than conventional methods of hypochlorite treatment. In this study, the effects of injection pressure (in the range of 10-30 psig) on the mechanical, pore sizes and hydraulic permeability of the polysulfone (PSf) hollow fibrous membranes have been investigated. The pore sizes and pore structures were analyzed by atomic force microscope (AFM) and scanning electron microscope (SEM) images. Results showed that the pore sizes and hydraulic permeability of the hollow fibers are increased with increase in injection pressure of sodium hypochlorite. On the contrary, the mechanical properties of the membranes dropped after an increase in injection pressure from 10 to 30 psig. This decrement could have been occurred due to removal of the polyvinyl pyrrolidone (PVP) from the polymer matrix of the PSf hollow fibers. These results can be useful for control and adjustment of the process parameters of hypochlorite treatment of the hollow fibrous membranes.
Keywords
Hypochlorite treatment
Hollow fibers
Polysulfone (PSf)
Injection pressure
Hydraulic permeability

Subjects

[1] Yang Q., Chung T.C., Weber M., Microscopic Behavior of Polyvinyl Pyrrolidone Hydrophilizing Agents on Phase inversion Polyethersulfone Hollow Fiber Membranes for Memofiltration, Journal of Membrane Science, 326: 322-331 (2009).
[2] Qin J., Wong V., Li Y., Liu Y., A High Flux ultrafiltration membrane spun from PSU/PVP (K90)/DMF/1,2-Propanediol, Journal of Membrane Science, 211: 139-147 (2003).
[3] Xu Z.L., Chung T.S., Huang Y., Effect of Poly (vinyl pyrrolidone) Molecular Eeights on Morphology, Oil/Water Separation, Mechanical and Thermal Properties of Polyetherimide/Poly-(Vinylpyrrolidone) Hollow Fiber Membranes, Journal of Applied Polymer Science, 74: 2220-2233 (1999).
[4] Higuchi A., Chemically Modified Polysulfone Hollow Fibers with Vinylpyrrolidone Having Improved Blood Compatibility, Biomaterial, 23: 2659-2666 (2002).
[5] Hayama M., Yamamoto K., Kohori F., Sakai K., How Polysulfone Dialysis Membranes Containing Polyvinylpyrrolidone Achieve Excellent Biocompatibility?, Journal of Membrane Science, 234: 41-49 (2004).
[6] Yang Q., Chung T. C., Santoso Y.E., Tailoring Pore Size and PoreSize Distribution of Kidney Dialysis Hollow FiberbMembranes via Dual-Bath Coagulation Approach, Journal of Membrane Science, 290: 153-163 (2007).
[7] Roesink H.D., "Microfiltration: Membrane Development and Module Design", Ph.D. Thesis, University of Twente, Enschede, The Netherlands, (1989).
[8] Weink I., Meuleman E., Borneman Z., Van Den Boomgaard T., Smolders C., Chemical Treatment of a Polymer Blend: Mechanism of the Reaction of Hypochlorite with Poly (Vinyl Pyrrolidone), Journal of Polymer Science Part A: Polymer Chemistry, 33: 49-54 (1995).
[9] Zhang Y, Wang J., Gao F., Tao H., Chen H. Zhang H., Impact of Sodium Hypochlorite (NaClO) on Polysulfone (PSF) Ultrafiltration Membranes: The Evolution of Membrane Performance and Fouling Behavior, Separation and Purification Technology, 175: 238-247 (2017).
[10] Saghafi R., Zarrebini M., Semnani D., Mahmooudi M. R., The Effect of Bore Fluid Type on Performance of Treated Polysulfone Hollow-Fiber Membrane, Textile Research Journal, 85(3): 281-293 (2014).
[11] Saghafi R., Zarrebini M., Semnani D., Mahmooudi M. R., Novel Method for Treatment of Hollow fiber Kembranes using Hypochlorite, The Journal of The Textile Institute, 105: 962-970 (2014).
[12] Saghafi R., Zarrebini M., Semnani D., Mahmooudi M. R., High Pressure Injection Technique for Hypochlorite Treatment of Polysulfone Hollow Fibre Membranes, Indian Journal of Fibre & Textile Research, 40: 405-413 (2015).
[13] Saghafi R., Effect of Hybrid Post Treatments on the Structural Property and Water Fux of Polysulfone Hollow Fiber Membrane, Fibers and Polymers, 18(1): 41-49 (2017).
[14] Khayet M., Khulbe K.C., Matsuura T., Characterization of Membranes for Membrane Distillation by Atomic Force Microscopy and Estimation of Their Water Vapor Transfer Coefficients in Vacuum Membrane Distillation Process, Journal of Membrane Science, 238: 199-211 (2004).
[15] Kim J.Y., Lee H.K., Kim S.C., A New Modeling of Asymmetric Membrane Formation in Rapid Mass Transfer System, Journal of Membrane Science, 163: 69-77 (1999).
[16] Liao Z., Klein E., Poha C.P., Huanga Z., Lu J, Hardy P.A., Gao D., Measurement of Hollow Fiber Membrane Transport Properties in Hemodialyzers, Journal of Membrane Science, 256(1-2): 176-183 (2005).
[17] Rouaix S., Causserand C., Aimar P., Experimental Study of the Effects of Hypochlorite on Polysulfone Membrane Properties, Journal of Membrane Science, 277(1-2): 137-147 (2006)
[18] "Operation and Maintenance Manual - UF-6-HF Ultrafiltration System'', Con-Serv Manufacturing, (2013).
[19] Jacangelo J.G., Adham S., Michel J., "Membrane Filtration for Microbial Removal", Denver, CO: AWWA Research Foundation and American Water Works Association. ISBN 0898978943 (1997).
[20] Sakai K., Ozawa K., Mimura R., Ohashi H., Comparison of Methods for Characterizing Microporous Membranes for Plasma Separation, Journal of Membrane Science, 32(1): 3-17 (1987).