Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

Synthesis of Nanocomposites of Single-Wall Carbon Nanotubes Coated with ZnO Nanoparticles in a Matrix of Poly Methyl Methacrylate and Study of Its Optical Properties

Document Type : Research Article

Authors
Saina Shafiee Hasani
Zohreh Ghazi Tabatabaei
Department of Applied Chemistry, Ahar Branch, Islamic Azad University, Ahar, I.R. IRAN
Abstract
In this study, the composites of Single Wall Carbon NanoTubes (SWCNTs) functionalized with zinc oxide nanoparticles based on poly (methyl methacrylate) (PMMA) as an optical sensor were prepared by the co-precipitation method as a part of the optical sensor. Nanoparticles synthesized were identified and characterized by analysis FESEM, EDX, XRD, and FT-IR. The average size of ZnO nanoparticles doped in carbon nanotubes was estimated at about 22nm using XRD techniques. To characterize the optical properties of carbon nanotubes as a base and a basic element with high detection capability in sensors was used UV-vis spectrophotometric and the results showed, the use of carbon nanotubes functionalized with ZnO in the PMMA matrix makes improved coverage properties of nano-composite against the UV radiation by reducing the gloss and surface clarity and the transmittance of UV radiation was zero. Also, the spectral reflectance values of the prepared samples are measured by a reflectance spectrophotometer in the visible region from 400-700 nm. The color parametric values and the blackness index are calculated at about 3.65. It was observed that in the samples containing functional carbon nanotubes the reflectivity was reduced 50% and had a better blackness.
Keywords
Polymethyl methacrylate
Single Wall Carbon Nanotubes (SWCNTs)
Zinc oxide
Optical Properties

Subjects

[1] Zein S.H.S., Boccaccini A.R., Zainal W.N.H.W, Effect of Manganese Oxide on Theproperties of Polyvinyl Alcohol Multi-Walled Carbon Nanotube Composites as Model Supercapacitors Material, World Appl. Sci. J. 6 (6): 737–747 (2009).
[2] Cano L., Gutierrez J., Tercjak A., Rutiletio2 Nanoparticles Dispersedinaself- Assembled Polystyrene-Block-Polymethylmethacrylat Ediblock Copolymer Template, J. Phys. Chem. 117: (2):1151–1156 (2013).
[3] Pandey A., Prasad A., Moscatello J.P., Yap Y.K., Stable Electron Field Emission from PMMA CNT Matrices, ACS Nano, 4 (11): 6760–6766(2010).
[4] Tang B. Z, Xu H. Y., Preparation, Alignment and Optical Properties of Soluble Poly (Phenyl Acetylene) Wrapped Carbon Nanotubes, Macromolecules, 32(8): 2569-2576(1999).
[5] Yang Z., Lijie C., James A.B., Li S., Ajayan P.M., Experimental Observation of an Extremely Dark Material Made by a Low-Density Nanotube Array, Nano Lett., 8(2): 446-451 (2008).
[6] Sun H., Shen X., Cui S., Xu N., Preparation and Absorption Properties in Near Infrared Wavelength of Carbon Nanotubes/Acrylate Coatings, Chin. J. Chem. Phys., 6 (20): 784-788 (2007).
[7] Asakuma N., Fukui T., Toki M., Imai H., Low-Tempera-Ture Synthesis of ITO Thin Films Using an Ultraviolet Laser for Conductive Coating on Organic Polymer Substrates,J. Sol-Gel Sci. Technol., 27(1): 91-95 (2003).
[8] Weon J.I., Creasy T.S., Sue H.J., Mechanical Behavior of Poly Methyl Metha Crylate with  Molecules Oriented Via Simple Shear, Polym.Eng.Sci., 45 (3): 314–324 (2005).
[9]Haghighat F.,  Mokhtary  M., Mortazavi S., Preparation and Characterization of Poly Vinyl Pyrrolidone / Carboxyl Functionalized Multiwalled Carbon Nanotube Nanocomposite, Iran. J. Chem. Chem. Eng.(IJCCE), 36 (1):159-167 (2017).
[10] Moezzi A., Mcdonagh A.M., Cortie M.B., Zinc Oxide Particles: Synthesis, Properties and Applications, J. Chem. Eng., 185: 1–22 (2012).
[11] Usman Ali S.M., Alvi N.H., Ibupoto  Z., Nur O., Willander M., Danielsson B., Selective Potentiometric Determination of Uric Acid With Uricase Immobilized on Zno Nanowires, Sens. Actuators B Chem, 152: 241–247 (2011).
[12] Ates E.S., Unalan H.E., Zinc Oxide Nanowire Enhanced Multifunctional Coatings for Cotton Fabrics, Thin Solid Films, 520 (14): 4658–4661 (2012).
[13] Dhall S.,  Jaggi N., Highly Dispersed Platinum Sputtered Multiwall Carbon Nanotubes Based Hydrogen Gas Sensor at Room Temperature, Sensors and Actuators A: Physical, 224: 50-56 (2015).
[14] Karami Horastani Z., Sayedi S.M., Sheikhi M.H., Effect of Single Wall Carbon Nanotube Additive on Electerical Conductivity and Methane Sesitivity of Sno2, Sensors and Actuators B, 202: 461-468 (2014).
[15] Llobet E., Gas Sensors Using Carbon Nanomaterials: A Review, Sensors and Actuators B: Chemical, 179: 32-45 (2013).
[16] Liu J., Rinzle, A.G., Dai H., Hafner J.H., Bradley R.K., Boul P.J., Lu A., Iverson T.,  Shelimov K.B., Huffman C.B., Fullerene Pipes, Science, 280 (5367): 1253-1256 (1998).
[17] Saleh, T.A., The Influence of Treatment Temperature on the Acidity of MWCNT Oxidized by HNO3 or Mixture of HNO3/H2SO4, Applied Surface Science, 257(17): 7746- 7751 (2011).
[18] Zahedniya, M., Ghazi Tabatabaei, Z., Investigation of BTEX Removal from Aqueous Solution by Single Wall Carbon Nanotubes Decorated with Zno, Journal of Water And Wastewater, 29(2): 1-11(2018).
[19] Zhu L.P., Huang W.Y., Ma L.L., Fu S.Y., Yu Y., Jia Z.J., Synthesis And Characteristics of Zno-Cnts Nanocomposites, Acta Phys. Chim. Sin., 22 (10): 1175-1180 (2006).
[20] Du F., Fischer J.E., And Winey K.I., Coagulation Method for Preparing Single-Walled Carbon Nanotube/Poly(Methylmethacrylate) Composites and Their Modulus, Electrical Conductivity, and Thermal Stability, J. Polym Sci., Part B; Polym. Phys., 41: 333- 338 (2003).
[21] Wang Z., Xie G., Wang X., Zhang Z., Rheology and Dispersion Behavior of High- Impact Polystyrene/Ethylene–Vinyl Acetate Copolymer/TiO2 Nanocomposites, Journal of Applie Polymer Science, 100 (6): 4434-4440 (2006).
[22] Kausch H.H., Michler G.H., Effect of Nanoparticle Size and Size-Distribution on Mechanical Behavior of Filled Amorphous Thermoplastic Polymer, Journal of Applied Polymer Science, 105 (5): 2577-2584 (2007).
[23] Chen W.X., Tu J.P., Wang L.Y., Gran H.Y., Xu Z.D., Zhang X.B., Tribological Application of Carbon Nanotubes in a Metal-Based Composite Coating and Composites, Carbon; 41(2): 215-222 (2003).
[24] Zhu L.P., Huang W.Y., Ma L.L., Fu S.Y., Yu Y., Jia Z.J., Synthesis and Characteristics of ZnO- Cnts Nanocomposites, Acta Physico Chimica Sinica , 22 (10): 1175-1182 (2006).
[25] Song  X., Li R., Li H., Hu Z., Mustapha Z. & Lin M., Characterization and Quantification of Zinc Oxide and Titanium Dioxide Nano-Particles In Foods, Food Bioprocess Technol, 7 (2): 456–462 (2014).
[26] Westland S., Cheung T.L.V., Lozman O.R., “A Metric for Predicting Perceptual Blackness”, Presented at the 14th Color Imaging Conference Final Program and Proceedings, Society for Imaging Science and Technology, Arizona, 14-17(2006).
[27] Lee J., Easteal A. J., Metson J. B., Properties of Nano Zno/ Poly(Vinyl Alcohol)/ Poly (Ethylene Oxide) Composite Thin Films, Current Applied Physics, 8 (1): 42-47 (2008).
[28] Alizadeh N. , Safi M., Akbar Yousefi A., PMMA/CB and PMMA/Mwcnts Nanocomposites: Assessments Through Optical Behavior,Iranian Journal of Polymer Science and Technology, 25 (4): 255-263(2012).
[29] He Z., Zhong C., Su S., Xu M., Wu H., Cao Y., Enhanced Power-Conversion Efficiency in Polymer Solar Cells Using an Inverted Device Structure, Nature. Photon, 6: 591–595 (2012).
[30] Mizuno K., Ishii J., Kishid H., Hayamizu Y., Yasuda S., Futaba D.N., Yumura M., Hata K., A Black Body Absorber from Vertically Aligned Single-Walled Carbon Nanotubes, Appl. Phys. Sci., 15: 6044-6047(2009).
[31] Skompska M., Hybrid Conjugated Polymer/Semiconductor Photovoltaic Cells, Synthetic Metals, 160 (2): 1–15 (2010).