Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

Optimization of the Separation Fractional of Dispersum and Gadolinium under Uncertainty Conditions

Document Type : Research Article

Authors
Seyyed Mohammad Seyyed Alizadeh Ganji
Mohammad Hayati
Faculty of Engineering, Lorestan University, Khorramabad, I.R. IRAN
Abstract
Rare elements in nature are often found in the form of oxide, and since they are very similar in physical and chemical properties, their separation is very difficult. Hence, the study and selection of the most appropriate methods for the separation of rare elements are very important and necessary. Therefore, in this first step, in order to model and optimize the effective factors on improving the separation of Dispersum and Gadolinium, five factors including pH, Cyanex 272 to Depa ratio, solvent extraction’s concentration, time and lactic acid’s concentration were selected. Then, DX7 software was used to design the experiments and based on that, 29 tests were determined. But on the other hand, in carrying out experiments, such things as weighing with the device, preparing solutions with a specific concentration, removing different volumes, and etching of the items that can cause the error and therefore the uncertainty is why the discussion of probabilistic analysis in order to Modeling under conditions of uncertainty can be very useful for the assurance of the results. For this purpose, in the second step, based on the data obtained from the experiments and the relationships obtained between the input and output variables, first, the type and characteristics of the probability distribution function, each of the five effective input parameters were determined and based on them and with Considering the simulation results, the characteristics of the distribution parameters of the output parameters (percent recovery of dysprosium and gadolinium) were obtained.
Keywords
Rare elements
Separation fractional
Experimental design
Uncertainty
Monte Carlo simulation

Subjects

[1] Haxel G.B., Hedrick J.B., Orris G.J., Stauffer P.H., Hendley J.W., Rare Earth Elements Critical Resources for High Technology. USGS Facts Sheet 087-02, (2002).
[2] Jorjani E., Bagherieh A.H., Rezai B., Determination of Rare Earth Elements in Products of Chadormalu Iron ore Beneficiation Plant (Iran) from Beneficiation Point of View, Iranian Journal of Chemistry and Chemical Engineering (IJCCE), 26(4): 11-18 (2007).
[3] Jia Q., Tong S., Li Z., Zhou W., Li H., Meng S., Solvent Extraction of Rare Earth Elements
with Mixtures of Sec-octylpHenoxy Acetic Acid and bis(2,4,4-trimethylpentyl) DithiopHospHinic Acid, Separation and Purification Technology, 64: 345-350 (2009).
[4] Shanshan T., Xiaowei Z., Naizhong S., Qiong J., Weihong Z., Wuping L., Solvent Extraction Study of Rare Earth Elements from Chloride Medium by Mixtures of Sec-nonylpHenoxy Acetic Acid with Cyanex301 or Cyanex302. Hydrometallurgy, 100(1-2): 15-19 (2009).
[5] Coleman H.W., Steele W.G., "Experimentation and Uncertainty Analysis for Engineers", John Wiley & Sons, Inc., New York, (1999).
[6] Christian j.T., Beacher G.B., “Reliability and Probability in Stability Analysis”, ASCE,Geotechnical Spatial Publication, 1071-1111 (1992).
[7] Sari M., Karpuz C., Ayday C., Estimating Rock Mass Properties using Monte Carlo Simulation: Ankara Andesites, Computers & Geosciences, 36(7): 959-969 (2010).
[8] Fenton A., Griffiths D.V., Bearing Capacity of Rough Rigid Strip Footing on Cohesive Soil, Probabilistic Study, Journal of Geotechnical and Geo Environmented Engineering, 128(9): 743-755 (2002).
[9] Ghaffari A., Hayati M., Shekholeslami A., Probability and Sensitivity Analysis in Flotation Circuit of Bama Lead and Zinc Processing Plant Using Monte Carlo Simulation Method. Mineral Processing and Extractive Metallurgy Review, 33(6): 416-426 (2012).
[10] Mellado M.E., Gálvez E.D., Cisternas L.A., Stochastic Analysis of Heap Leaching Process
via Analytical Models, Minerals Engineering, 33: 93-98 (2012).
[11] Zou R., Lung W.S., Guo H., Neural Network Embedded Monte Carlo Approach for Water Quality Modeling under Input Information Uncertainty, Journal of Computing in Civil Engineering, 16(2): 135-142 (2002).
[12] Salas J. D., Shin H.S., Uncertainty Analysis of Reservoir Sedimentation, Journal of Hydraulic Engineering, 125(4): 339-350 (1999).
[13] El Safadi E.A., Adrot O., Flau J.M., Advanced Monte Carlo Method for Model Uncertainty Propagation in Risk Assessment, IFAC-Papers Online, 48(3): 529-534 (2015).
[14] Ahammed M., Melchers R.E., Gradient and Parameter Sensitivity Estimation for Systems Evaluated Using Monte Carlo Analysis, Reliability Engineering and System Safety, 91(5): 594-601 (2006).
[15] Cadini F., Sanctis J.D., Girotti T., Zio E, Luce A., Taglioni A., Monte Carlo-Based Assessment of the Safety Performance of a Radioactive Waste Repository, Reliability Engineering and System Safety, 95(8): 859-865 (2010).
[16] Cadini F., Sanctis J.D., Bertoli I., Zio E., Monte Carlo Simulation of Radionuclide Migration
in Fractured Rock for the Performance Assessment of Radioactive Waste Repositories, Reliability Engineering and System Safety, 111: 241-247 (2013).
[17] Cadini1 F., Gioletta A., A Bayesian Monte Carlo-Based Algorithm for the Estimation of Small Failure Probabilities of Systems Affected by Uncertainties, Reliability Engineering and System Safety, 153: 15-27 (2016).
[18] Dehghani H., Ataee-pour M., Esfahanipour A., Evaluation of the Mining Projects under Economic Uncertainties Using Multi Dimensional Binomial Tree, Resources Policy, 39(1): 124-133 (2014).
[19] Robert C.P., Casella. G., "Monte Carlo Statistical Methods", 2nd ed. Springer-Verlag,
New York, (2004).
[20] Wills B.A., "Mineral Processing Technology", 7th ed. Elsevier, Oxford, (2006).