Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

Experimental Investigation of Thermal Marangoni Effect on Bypassed Oil Recovery

Document Type : Research Article

Authors
Mohammad Masoudi 1
Maryam Khosravi 2
Behzad Rostami 1
Pejman Abolhosseini 1
1 Institute of Petroleum Engineering, College of Engineering, University of Tehran, Tehran, I.R. IRAN
2 IOR Research Institute, National Iranian Oil Company, Tehran, I.R. IRAN
Abstract
In this paper, the effect of the InterFacial Tension (IFT) gradient caused by the temperature changes (Benard-Marangoni phenomenon), as a new EOR method has been investigated. For a proper understanding and visualizing the mechanism, glass micromodels were used. Carbon dioxide and methane were injected into n-decane saturated micromodel. The gas injection was conducted in different pressure and temperature. The cold gas injection was compared with isotherm gas injection as the zero level of Marangoni flow. The presented results show the significant impact of thermal Marangoni convection on the recovery of bypassed oil and introduced Benard-Marangoni convection as an important mechanism of oil recovery especially in low-pressure reservoirs.
Keywords
Cold gas injection
Gas injection in the fracture
Thermal Marangoni convection
Micromodel

Subjects

[1] T. D. Van Golf-Racht, Fundamentals of fractured reservoir engineering: Elsevier, 1982.
[2] M. Khosravi, A. Bahramian, M. Emadi, B. Rostami, and E. Roayaie, "Effect of Marangoni flow on recovery of bypassed oil during CO2 injection," Journal of Petroleum Science and Engineering, vol. 114, pp. 91-98, 2014.
[3] A. D'Aubeterre, R. Da Silva, and M. Aguilera, "Experimental study on Marangoni effect induced by heat and mass transfer," International communications in heat and mass transfer, vol. 32, pp. 677-684, 2005.
[4] H. Bernard, "Les tourbillons cellulaires dans une nappe liquide [The cellular vortices in a liquid layer]," Rev Gén Sci Pure Appl, vol. 11, pp. 1261-1271, 1900.
[5] L. Rayleigh, "LIX. On convection currents in a horizontal layer of fluid, when the higher temperature is on the under side," The London, Edinburgh, and Dublin Philosophical Magazine and Journal of Science, vol. 32, pp. 529-546, 1916.
[6] M. J. Block, "Surface tension as the cause of Bénard cells and surface deformation in a liquid film," Nature, vol. 178, pp. 650-651, 1956.
[7] J. Pearson, "On convection cells induced by surface tension," J. Fluid Mech, vol. 4, pp. 489-500, 1958.
[8] H. Groothuis and F. Zuiderweg, "Influence of mass transfer on coalescence of drops," Chemical Engineering Science, vol. 12, pp. 288-289, 1960.
[9] A. C. Lam, R. S. Schechter, and W. H. Wade, "Mobilization of residual oil under equilibrium and nonequilibrium conditions," Society of Petroleum Engineers Journal, vol. 23, pp. 781-790, 1983.
[10] H. Pratt, "Marangoni flooding with water drives: A novel method for EOR?," in SPE Asia-Pacific Conference, 1991.
[11] H.-H. Lu, Y.-M. Yang, and J.-R. Maa, "Effect of artificially provoked Marangoni convection at a gas/liquid interface on absorption," Industrial & engineering chemistry research, vol. 35, pp. 1921-1928, 1996.
[12] P. A. Lyford, H. Pratt, D. C. Shallcross, and F. Grieser, "The marangoni effect and enhanced oil recovery Part 1. Porous media studies," The Canadian Journal of Chemical Engineering, vol. 76, pp. 167-174, 1998.
[13] M. Khosravi, B. Rostami, M. Emadi, and E. Roayaei, "Marangoni flow: An unknown mechanism for oil recovery during near-miscible CO 2 injection," Journal of Petroleum Science and Engineering, vol. 125, pp. 263-268, 2015.
[14] J. Kuneš, Dimensionless physical quantities in science and engineering: Elsevier, 2012.
[15] A. Georgiadis, F. Llovell, A. Bismarck, F. J. Blas, A. Galindo, G. C. Maitland, et al., "Interfacial tension measurements and modelling of (carbon dioxide+n-alkane) and (carbon dioxide+ water) binary mixtures at elevated pressures and temperatures," The Journal of Supercritical Fluids, vol. 55, pp. 743-754, 2010.
[16] R. Amin and T. N. Smith, "Interfacial tension and spreading coefficient under reservoir conditions," Fluid phase equilibria, vol. 142, pp. 231-241, 1998.
[17] C. A. Conn, K. Ma, G. J. Hirasaki, and S. L. Biswal, "Visualizing oil displacement with foam in a microfluidic device with permeability contrast," Lab on a Chip, vol. 14, pp. 3968-3977, 2014.
[18] S. Thomas, "Enhanced oil recovery-an overview," Oil & Gas Science and Technology-Revue de l'IFP, vol. 63, pp. 9-19, 2008.
[19] K. Verschueren, Handbook of environmental data on organic chemicals: Wiley, 2001.
[20] Simant R. Upreti and A. K. Mehrotra, "Diffusivity of CO2, CH4, C2H6 and N2 in athabasca bitumen," Journal of Chemical Engineering, vol. 80, pp. 116-125, 2002.
[21] F. Civan and M. L. Rasmussen, "Determination of gas diffusion and interface-mass transfer coefficients for quiescent reservoir liquids," SPE Journal, vol. 11, pp. 71-79, 2006.
[22] P. G. Fogg, Carbon Dioxide in non-aqueous solvents at pressures less than 200 kPa vol. 50: Elsevier, 2013.
[23] R. Nguele, K. Sasaki, M. R. Ghulami, Y. Sugai, and M. Nakano, "Pseudo-phase equilibrium of light and heavy crude oils for enhanced oil recovery," Journal of Petroleum Exploration and Production Technology, vol. 6, pp. 419-432, 2016.
[24] Y. M. Naziev and M. Aliev, "Thermal conductivity and specific heat of n-decane at various temperatures and pressures," Journal of engineering physics, vol. 24, pp. 717-720, 1973.