Nashrieh Shimi va Mohandesi Shimi Iran

Nashrieh Shimi va Mohandesi Shimi Iran

Risk Assessment in the Process of Leaking Pipelines and Storage Equipment of Oil and Petroleum Products

Document Type : Research Article

Authors
Behruz Mirzayi 1
Aziz Babapoor 1
Alireza Dehghan Bidakhti 2
Meysam Paar 1
1 Department of Chemical Engineering, University of Mohaghegh Ardabili, Ardabil, I.R. IRAN
2 Department of Chemical Engineering Ferdowsi University of Mashhad, Mashhad, I.R. IRAN
Abstract
Currently reserves are proven to be the most economical method of oil and gas storage worldwide. In this work, the effects of different parameters on possible incidents of oil storage tank via modeling and analysis with the PHAST software was investigated. In this modeling, a pressurized crude oil storage tank with an input pipeline was considered and the possibility of leakage from the pipeline was studied. The results showed that, depending on the weather conditions, the diameter of the simulated oil pond can be extended up to 40 meters. Moreover, in the wind and assuming a fire pool in the oil pond, the heat radiations with an intensity of 4 kW/m2 can affect the pond up to a distance of 20 meters. The areas affected by the wave from explosion and flash fire were also 27 and 30 meters, respectively. The results also showed a high evaporation rate of oil the first time  and after about 2000 seconds, due to lower oil in the pond, the rate of evaporation is reduced and leads to a decrease in the radius of the pond. The rising storage tank temperature, as well as the amount of evaporated oil over time, are the most important issues, which make it difficult to control the system and also endanger the safety and health of the environment. 
Keywords
Oil storage
Oil products
Risk assessment
Incident
Safety
Modeling

Subjects

 [1] Al Hagrey S.A., 2D Optimized Electrode Arrays for Borehole Resistivity Tomography and CO2 Sequestration Modelling, Pure Appl. Geophys, 169: 1283-1292, (2012).
[2] Asnaashari A., Brossier R., Garambois S., Audebert F., Thore P., Virieux J., Time-Lapse Seismic Imaging Using Regularized Full-Waveform Inversion with a Prior Model: Which Strategy?,   Geophys Prospect, 63: 78-98, DOI: 10.1111/1365-2478.12176, (2015).
[3] Bachu S., Bennion B., Effects of in Situ Conditions on Relative Permeability Characteristics of CO2-Brine Systems, Environ Geol, 54: 1707-1722, DOI: 10.1007/s00254-007-0946-9, (2008).
[4] Kuan, Yeng S., “Design, Construction and Operation of the Floating Roof Tank”, Thesis of bachelor of Engineering, Faculty of Engineering and Surveying, University of Southern Queensland, (2009).
[5] دلبری، هنگامه؛ توکلی، امید، "رویکردهای فناوری، مدیریتی و کاربردی در ذخیره سازی نفت و فراورده ­های نفتی"، اولین همایش ذخیره ­ساcی زیرزمینی نفت و گاز، 1393.
 [6] Naithani A.K.,  Underground Rock Caverns for Strategic Crude Oil Storage in India – Nature of Studies, Design and Construction,  Current Science, 103: 490-496, (2012).
 [7] Rosenfeld A.B., Gordon D.L., Guerin-McManus M., “Reinventing the Well Approaches to Minimizing the Environmental and Social Impact of Oil Development in the Tropics”, Conservation International. (1997).
 [8] Witlox H.W.M., Harper M., Oke A., Stene J., “PHAST Validation of Discharge and Atmospheric Dispersion for Pressurised Carbon Dioxide Releases”, Loss Prevention in the Process Industries, 1-13, (2013).
 [9] Dan S., Park K., Kim T., Shin D., Explosion Simulations for the Quantitative Risk Analysis of New Energy Filling Stations, Korean Institute of Gas, 15: 60-67, (2011).
 [10] Pandya N., Marsden E., Floquet P., Gabas N., “Toxic Release Dispersion Modelling with PHAST: Parametric Sensitivity Analysis”, ICISAP - 3rd International Conference on Safety & Environment in Process Industry, Rome, Italy, (2008).
 [11] Ganci F., Carpignano A., Mattei N., Carcassi M.N., Hydrogen Release and Atmospheric Dispersion: Experimental Studies and Comparison with Parametric Simulations, Hydrogen Energy, 36: 2445-2454, (2011).
 [12] Pontiggia M., Landucci G., Busini V., Derudi M., Alba M., Scaioni M., Bonvicini S., Cozzani V., Rota R., CFD model simulation of LPG dispersion in urban areas, Atmospheric Environment, 45: 3913-3923. (2011).
[13] هاشمی، اعظم السادات؛ کرباسی، عبدالرضا؛ عتابی، فریده؛ "ارائه الگوی ارزیابی اثرات زیست محیطی پروژه­ های اکتشاف و استخراج نفت و گاز بر محیط­ های دریایی"، پنجمین همایش ملی انرژی، (1384).
[14] امامی نیری، محمد؛ مدل­ سازی فیزیک سنگی در مخازن ماسه سنگی ـ مروری بر مدل ­های نظری و یک مثال کاربردی، نشریه ژئومکانیک نفت، (2) 1: 74 تا 85، (1393).
[15] صفرزاده، محمد امین؛ مطهری، مهدیا؛ بهینه ­سازی همزمان ذخیره­سازی زیرزمینی گاز و ازدیاد برداشت نفت در فرایند تزریق گاز کربن دی اکسید با استفاده از روش الگوریتم ژنتیک چند هدفه، نشریه شیمی و مهندسی شیمی ایران، (3)73: 85 تا 97 (1393).
[16] زرگری مرندی، سمیرا؛ وفایی سفتی، محسن؛ باغبان صالحی، مهسا؛ موسوی اقدم، عاطفه؛ دادوند کوهی، احمد؛ کنترل تولید شن: کاربرد هیدروژل­ ها، روشی نوین در مخازن نفتی، (1)83: 215 تا 227 (1396).
[17] باقری، مجتبی؛ بدری، ناصر؛ رشتچیان، داود؛ اقبالیان، هوشنگ؛ تعیین حریم ایمن خطوط لوله انتقال گاز ترش به روش ارزیابی کمی ریسک،  نشریه شیمی و مهندسی شیمی ایران، (2)32: 57 تا 71 (1392).
[18] Canter L.W., “Environmental Impact Assessment”, McGraw-Hill International Edition, 2nd ed. (1996).